ARDUINO MKR WAN 1300 (LORA CONNECTIVITY)

Marke: Arduino

Produktcode: arduino-mkr-wan-1300

Verfügbar: Auf Lager

EAN / Barcode: 813747020558

Versand nach Deutschland:
  • 2 - 3 Werktage (DHL)
  • €44.95

    Arduino MKR WAN 1300 has been designed to offer a practical and cost effective solution for makers seeking to add Lo-Ra connectivity to their projects with minimal previous experience in networking. It is based on the Atmel SAMD21 and a Murata  CMWX1ZZABZ Lo-Ra module.

    The design includes the ability to power the board using two 1.5V AA or AAA batteries or external 5V. Switching from one source to the other is done automatically. A good 32 bit computational power similar to the MKR ZERO board, the usual rich set of I/O interfaces, low power Lo-Ra communication and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor. The USB port can be used to supply power (5V) to the board. The Arduino MKR WAN 1300 is able to run with or without the batteries connected and has limited power consumption.

    Warning: Unlike most Arduino & Genuino boards, the MKR WAN 1300 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.

    You can find here your board warranty informations.

    Getting Started

    You can find in the Getting Started section all the information you need to configure your board, use the Arduino Software (IDE), and start tinker with coding and electronics.

    Need Help?

    Specs

    Microcontroller SAMD21 Cortex-M0+ 32bit low power ARM MCU
    Board Power Supply (USB/VIN) 5V
    Supported Batteries(*) 2x AA or AAA
    Circuit Operating Voltage 3.3V
    Digital I/O Pins 8
    PWM Pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)
    UART 1
    SPI 1
    I2C 1
    Analog Input Pins 7 (ADC 8/10/12 bit)
    Analog Output Pins 1 (DAC 10 bit)
    External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)
    DC Current per I/O Pin 7 mA
    Flash Memory 256 KB
    SRAM 32 KB
    EEPROM no
    Clock Speed 32.768 kHz (RTC), 48 MHz
    LED_BUILTIN 6
    Full-Speed USB Device and embedded Host
    Antenna power 2dB
    Carrier frequency 433/868/915 MHz
    Working region EU/US
    Length 67.64 mm
    Width 25 mm
    Weight 32 gr.

    Customer Reviews

    No reviews yet
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)
    0%
    (0)